Synology DS1515+ Installation Guide download pdf (Page 10)

Chapter 2: Hardware Setup

Add a RAM Module on DiskStation

The optional Synology DDR3 RAM module is designed for DiskStation memory expansion. Follow the steps

below to install, check, or remove a RAM module on your DiskStation.

To install the RAM module:

Shut down your DiskStation. Disconnect all cables connected to your DiskStation to prevent any possible

damages.

Remove the 5 screws that secure the top case. Lift off the case and place it to the side.

Important:

When you remove the case, you expose sensitive internal components. Avoid touching anything other than

the memory assembly when you remove or add memory.

Insert the new memory module in the slot:

Align the notch on the gold edge of the module with the notch in the lower memory slot.

Tilt the card and push the memory into the slot. Make sure the module is pushed in all the way.

Usetwongerswithrm,evenpressuretopushdownonthememorymodule.Youshouldhearaclickwhen

the memory is inserted correctly.

Important:

Hold the memory module by its edges, and do not touch the gold connectors.

Replace the top case. Replace and tighten the 5 screws you removed in step 2.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

No comments

Synology DS1515+ Installation Guide Page 10